What is a Deep Cycle Gel Battery?
Deep Cycle Battery is the key component in various types of renewable energy systems that require the storage of electricity. A battery is essentially a storage vessel for electricity. It is a critical component heavily relied upon by the system as a whole. A battery bank can provide a relatively constant source of power when the grid is down, or during periods when your photovoltaic system is not producing power.
Deep cycle batteries are designed with thicker lead plates or tubular plates, which have less overall surface area than their thinner counterpart. Because of the reduced availability of surface area for chemical reactions, deep cycle batteries produce less current than an SLI type battery, yet they produce that current for longer periods of time. Deep cycle batteries can be discharged up to 80% DOD without damage depending on the model. In order to increase battery life, we recommend discharging deep-cycle batteries only down to 50% in order to increase battery life.
GEL MLG Series 12V
- Electric powered vehicle;
- Golf cars and buggy;
- Wheal chair;
- Power tool;
- Electric powered toy;
- Control system;
- Vacuum cleaner;
- Medical equipment;
Mainline Gel MLG series battery is specially designed to meet requirement of frequent cyclic and high temperature application such as board had, PVs etc. We use high quality separator and silica from the best European producers. And we use special technology to fill acid firstly then after about 20 hours charge and discharge, fill out all acid then fill in silica separately to make sure each cell can get enough silica and complete penetration of electrolyte through separators and plates pastes from top to bottom.
Long life design and free of maintenance
Mainline Gel MLG series of batteries are long life design and free of maintenance. Normally in the alloy of plate, the percentage of tin is 0,8%. For these batteries, we doubled the percentage of tin in the alloy. Also we change the percentage of Ca in this alloy.
- Valve regulated construction
Mainline Gel MLG series is the AGM (Absorbed Glass Mat) valve regulated (sealed) lead acid rechargeable type of batteries. The electrolyte is suspended in a specially formulated non woven glass mat separator. All the electrolyte is absorbed in this manner and provides a safe non-spillable battery.
- Gas recombination system
The gasses generated in the normal charge/discharge use of a rechargeable battery are internally recombined during normal operating parameters. In the fact in normal operational use, more than 99% of the gasses generated are recombined.
- Safety and automatic valve system
If the pressure is over 2-5 psi the safety valve will automatically open and reseal. The promise that there is no any excessive accumulation if gas in the battery.
- Heavy duty grids
The grids are made by heavy duty lead calcium tin alloy. This provides: the safety margin of performance condition, excellent recovery capacity from deep discharge, extra service life in either cycle or float application, low self-discharge when it is not in working.
- Float service life of battery
Mainline Gel MLG series batteries is designed for float life of 10 years at 20°C (68°F).
- Operation in any position
Because the batteries are sealed and all the acid is absorbed in the special separators, these batteries can be operated in both vertical and horizontal position.
- Wide operation temperature range
The batteries can be used in wide temperature range from -35°C to 45°C.
- Available in flame retardant ABS material for the battery case V0
The batteries cases can be made by flame retardant material V0. It depends on the requirement of customer.
|Model||Nom. Voltage (V)||Nom. Capacity, C10hr (AH)||Dimensions||H over Terminal||Weight|